| Number of receivers | 0 |
| Number of transmitters | 4 |
| Supply voltage (Nom) (V) | 5 |
| Signaling rate (Max) (Mbps) | 20 |
| IEC 61000-4-2 contact (+/- kV) | None |
| Fault protection (V) | -12 to 12 |
| Common mode range | -3 to 3 |
| Number of nodes | 32 |
| Isolated | No |
| ICC (Max) (mA) | 45 |
| Rating | Catalog |
| Operating temperature range (C) | 0 to 70 |
- Meets or Exceeds the Requirements of ANSI Standard EIA/TIA-422-B and ITU Recommendation V.11
- Designed to Operate up to 20 Mbaud
- 3-State TTL Compatible
- Single 5-V Supply Operation
- High Output Impedance in Power-Off Condition
- Complementary Output-Enable Inputs
- Improved Replacement for the AM26LS31
The four differential line drivers are designed for data transmission over twisted-pair or parallel-wire transmission lines. They meet the requirements of ANSI Standard EIA/TIA-422-B and ITU Recommendations V.11 and are compatible with 3-state TTL circuits. Advanced low-power Schottky technology provides high speed without the usual power penalties. Standby supply current is typically only 26 mA, while typical propagation delay time is less than 10 ns.
High-impedance inputs maintain low input currents, less than 1 uA for a high level and less than 100 uA for a low level. Complementary output-enable inputs (G and G\) allow these devices to be enabled at either a high input level or low input level. The SN75ALS192 is capable of data rates in excess of 20 Mbit/s and is designed to operate with the SN75ALS193 quadruple line receiver.
The SN75ALS192 is characterized for operation from 0°C to 70°C.
H = high level, L = low level, X = irrelevant, Z = high impedance (off)
